Baseball cap customization experience sharing: the golden ratio of hat logo size and location

When customizing baseball caps, the most torn thing is not the color, but how big and where to put the logo. If the ratio is right, the hat is like a brand model; if the ratio is wrong, no matter how expensive it is, it is like a gift hat.?

Let's talk about the golden ratio on the front: the width of the adult front piece is about 16-18cm, and the width of the logo is 1/3 to 2/5 of the visible width of the hat crown, which is about 5-7cm. The height is controlled at 2.5-4 cm. If you want to make a small standard, 3-4cm is more delicate; the trendy brand can reach 7-9cm, but you need to widen the hat crown or reduce the text.

The position is more critical. The front is centered, and the left and right white spaces must be the same. The lower edge of the logo is about 1.5-2 cm from the brim suture, and the upper edge is at least 2cm from the top suture. The center point is 0.5-1 cm higher than the visual center of the front piece, and it does not press the eyebrows or show the head length.

The side label is recommended to be 3-4cm wide, placed horizontally centered on the side, and do not press the side seam. The back label is placed 1-2cm above the adjustment buckle and 2-3cm wide. Small print should be enlarged, otherwise the embroidery is easy to paste. Remember to leave 0.8-1 cm margin around 3D embroidery, and change the thin lines to bold or the printing is more stable.

There are many failure cases: the logo occupies the front piece, like an advertising cap; the logo is lower than the eyebrow line, showing the face is short; the side mark is too far back, and the photo cannot be seen. When proofing, be sure to wear it to see the front, side, and head angle, and confirm the proportion before mass production.

If you are not sure, you can ask Shenzhen Yasenman Garment Co., Ltd. for hat shape and logo ratio suggestions. They have experience in customized proofing of baseball caps, and can adjust the size and position according to the head shape, process and wearing scene to reduce rework.

Remember the formula: the front logo width Technologies hat crown width × 0.35, the lower edge is 2cm away from the brim, and the upper edge is left blank ≥ 2cm. Draw the line first, then sample, and then mass-produce, basically no rollover.✅